Hyperion Atlas DSUMD Servo - 20mm / 53 g •Digital Servo •Fully programmable •Download Programming Manual •Download ATLAS Datasheet All Hyperion Atlas servos are fully programmable to define a range of important and useful features that will help you optimize your radio installation. · The servo should ideally use 5v logic for the signal, but many servos will accept a v signal without any problems including the Hyperion Atlas Digital servo I’m using (HP-DSACB). Below is a short video showing the servo move as the buttons are pressed. · Servo hole is the same size to fit W size servo. I needed to expand mm to fit DS Wing is joined with carbon tube like other Hyperion 25e planes. Fuselage is big and tall! It has enough space to fit brick or straight A 4S pack. Hyperion recommends either Z (kv )on 3S or lower kv Z with 4S (or 3S).
4-pin locking port. This is NOT for connecting to PC at this time, but is reserved for Hyperion ATLAS DIGITAL Servo programming now, and future connections later. Emeter II to PC interface is via SD Card file transfer. During a bench-test, the user may control the input signal to the ESC, by turning the potentiometer (Pot) on the Emeter. GRD BLACK wire Vcc RED wire Tx/Rx WHITE wire As mentioned, you may connect an Atlas Servo directly to USB adapter and program the servo, but only with servo disconnected from the model. Instead, it is much better practice to use a Hyperion "Y" cable (HP-WR) and modify it by disconnecting the RED wire from the connctor at USB. Hyperion Atlas DSUMD Servo - 20mm / 53 g •Digital Servo •Fully programmable •Download Programming Manual •Download ATLAS Datasheet All Hyperion Atlas servos are fully programmable to define a range of important and useful features that will help you optimize your radio installation.
Hyperion ATLAS Digital Servos are able to accept frame rates from 20Hz to Hz. As such they are well matched to the majority of Helicopter Gyro systems on the market today and work perfectly with popular Gyros such as Futaba GY However, ATLAS servos are NOT compatible certain high-end Gyros. 4-pin locking port. This is NOT for connecting to PC at this time, but is reserved for Hyperion ATLAS DIGITAL Servo programming now, and future connections later. Emeter II to PC interface is via SD Card file transfer. During a bench-test, the user may control the input signal to the ESC, by turning the potentiometer (Pot) on the Emeter. 23,17 € bez DPH. Hyperion Atlas DSFMD Servo - 20mm / 53 g. Digital Servo. Fully programmable. Download Programming Manual. Download ATLAS Datasheet. All Hyperion Atlas servos are fully programmable to define a range of important and useful features that will help you optimize your radio installation. A total of degrees available, plus.
0コメント