Chi potentiostat manual

The Model series are computerized general purpose potentiostat / bipotentiostat / galvanostat instruments. A typical application involves a rotating ring-disk electrode (RRDE), but these systems can also be used for other applications where dual channel measurements are essential, such as dual channel electrochemical detection. two 2 mm holes for manual purging. The center piece is the solution cell, and the bottom piece is for mounting purposes. Four screws are used to tighten an O-ring seal between the bottom and center pieces, with the quartz crystal sandwiched between them. The diameter of the quartz crystal is mm. The gold electrode diameter is mm. Your Reference Potentiostat/Galvanostat/ZRA has been supplied in a safe condition. This chapter of the Reference Operator's Manual contains some information and warnings that you must follow to insure continued safe operation of the Reference InspectionFile Size: 1MB.

The Model C series is designed for general purpose electrochemical measurements. The figure below shows the block diagram of the instrument. The system contains a fast digital function generator, high speed data acquisition circuitry, potentiostat, and a galvanostat (available only in select models). The potential control range is ± 10 V. The potential control range is ±10 V and the current range is ± mA. The instrument is capable of measuring current down to tens of picoamperes. The steady state current of a 10 µm disk electrode can be readily measured without external adapters. CH Instruments CHID Electrochemical Workstation Manuals, Datasheets, Drivers, Links. The Model series is designed for general purpose electrochemical measurements. The figure below shows the block diagram of the instrument. The system contains a fast digital function generator, high speed data acquisition circuitry, potentiostat, and a galvanostat (available only in select models).

EC Potentiostat / Galvanostat Ordering Information EC V / 1 A potentiostat / galvanostat $8, 30 QCM Quartz Crystal Microbalance $2, OCAB Replacement terminal cables $ ORTD RTD for EC $ Designed for EIS The EC was designed with electrochemical impedance spectroscopy (EIS) in mind. Instead of employing driven. CH Instruments was established in Our first instrument series, the Model series electrochemical analyzer / workstation, was introduced at the end of Since then, new products have been added to provide a full line of electrochemical instrumentation. generator, a data acquisition system, and a potentiostat / bipotentiostat / galvanostat. The potential control range is ±10 V, the current range is ±10 mA, and the maximum sampling rate is 1 MHz at bit.