Dladm manual page

dladm (1m) [opensolaris man page] The dladm command is used to administer data-links. A data-link is represented in the system as a STREAMS DLPI (v2) interface which can be plumbed under protocol stacks such as TCP/IP. # dladm create-aggr -l net0 -l net1 aggr1. To configure an Datalink Multipathing (dlmp) link aggregation of devices ixgbe1 (linkame net2) and ixgbe2 (linkname net3) with the name aggr2 enter following command: # dladm create-aggr -m dlmp -l net2 -l net3 aggr2. To list aggregations, enter following command:Missing: manual page. See the dladm(1M) manual page. The effectiveness of an aggregated link can be monitored by using the dlstat (1M) command if you are running Oracle Solaris 11+, for example: # dlstat show-aggr -r -i 1 aggr1.

The tnzonecfg database is described in the tnzonecfg(4) man page, which is part of the Solaris Trusted Extensions Reference Manual. -anycast. example% dladm create-iptun -T 6to4 -s myv4addr my6to4tun0. Then an IPv6 interface is plumbed over this link. Emulex Drivers Version for Solaris User Manual PA Rev. A 1. Introduction Supported Operating Systems 7 1. Introduction This document provides information for using the Emulex® Fibre Channel over Ethernet (FCoE) out-of-box drivers for Solaris StorEdge SAN Foundation Software. The bge driver is managed by the dladm (1M) command line utility, which allows VLANs to be defined on top of bge instances and for bge instances to be aggregated. See dladm (1M) for more details. You must send an explicit DL_ATTACH_REQ message to associate the opened stream with a particular device (PPA).

tunnel link (see dladm(1M)). The tunnel encapsulation limit controls how many more tunnels a packet can enter before it leaves any tunnel, that is, the tunnel nesting level. This option is obsolete, superseded by the dladm(1M) encaplimit link property.-encaplimit Disable generation of the tunnel encapsulation limit. This option. Oracle Solaris 11 uses profile-based networking configuration that be administered in one of two configuration modes: either manual or automatic. These modes differ in whether you configure the system manually using dladm and ipadm or by creating and applying network configuration profiles (NCPs). The ipadm command is a stable replacement for the ifconfig (1M) and ndd (1M) commands. It is used to create IP interfaces and to configure IP addresses. on those interfaces. It is also used to get, set or reset properties on. interfaces, addresses and protocols. For subcommands that take an addrobj, the addrobj specifies a unique.